oem brass electric solenoid valve factory

*Consult a chemical compatibility expert for correct seal and valve body material choice.Solenoid valves suitable for large flow capacity,suitable for water,air,fuel-oiĬompany Introduction: Zhejiang Hengsen Industrial Group Co., Ltd is a specialized manufacture base for refrigeration fittings, HVAC controls products, auto air-conditioner fittings, copper fittings, and disperse pipes in China. A prefiliter is recommended in your instillation to keep the orifice free from debris to ensure a tight seal. The valve will perform best with the coil in the upward position. The valves body has molded directional arrows that indicate the direction of flow. If installed outside the valve should be covered to prevent the coil from getting wet. This unit is fitted with an IP54 coil which makes it resistant to water. It can be connected directly by its lead wires. This valve requires 40 watts or 1.75 amps from a 24 VAC power source. For example 0 PSI this valve will flow approximately 45 gallons per minute and at 60 PSI 345 gallons per minute.

The orifice in this valve is 50mm and the Cv value is 45. The valves operation range of pressure is from 0 – 145 PSI. This means it will work well in a gravity fed system. This 2” valve requires no pressure to operate. This valve is gravity feed capable and requires no pressure to open or close.

This valve utilizes a Viton diaphragm which makes it compatible with a wide range of chemicals as well as temperatures up to 250☏. This valve is configured with a 2” female NPT input and output ports that can be easily connect with your own fittings. The 2” 24 Volt AC Brass solenoid valve is our highest flow normally closed valve in this configuration.

Oem brass electric solenoid valve factory